Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 409

show pppoe subinterface summary
host1:v0#show pppoe subinterface fastEthernet 1/1.1.1
PPPoE subinterface fastEthernet 1/1.1.1 is operStatusUp
URL String: http://www.urlofinterest.com
MOTM String: a horse walks into a bar
PPPoE subinterface fastEthernet 1/1.1.1 has a session id of 1
PPPoE Statistics
In Octets: 480
Out Octets: 256
In Packets:
Out Packets: 8
Example 2
host1:v0#show pppoe subinterface full
show pppoe subinterface fullPPPoE subinterface FastEthernet 2/0.11 is
operStatusUp (dynamic)
PPPoE subinterface FastEthernet 2/0.11 has a session id of 8
PPPoE subinterface FastEthernet 2/0.11 has source MAC address
0090.1a40.280a
PPPoE subinterface FastEthernet 2/0.11 has a MTU of 1494
PPPoE Statistics
In Octets: 165922
Out Octets: 108283
In Packets: 3607
Out Packets: 3608
See show pppoe subinterface.
Use to display the operational and administrative status of all configured PPPoE
subinterfaces.
Field descriptions
Total PPPoE subinterfaces Number of configured PPPoE subinterfaces
included in summary
Administrative Status
Up Number of subinterfaces not affected by manual administrative
intervention
Down Number of subinterfaces that cannot flow because of manual
administrative intervention
Operational Status
Up Number of subinterfaces that are operational
Down Number of subinterfaces that are not operational
LowerLayerDown Number of subinterfaces that are not operational
because an underlying interface is down
NotPresent Number of subinterfaces that are not operational because
hardware is unavailable
Example
Chapter 10: Configuring Point-to-Point Protocol over Ethernet
8
379
Monitoring PPPoE