Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 589

Chapter 15: Configuring Dynamic Interfaces
Router Name of the virtual router (VR) assigned to the profile; interfaces
created by the profile are attached to this VR
Directed Broadcast Enabled or disabled
ICMP Redirects Enabled or disabled
Access Route Addition Enabled or disabled
Network Address Translation Enabled or disabled; domain location (inside
or outside)
Source-Address Validation Enabled or disabled
Ignore DF Bit Enabled or disabled
Filter Option Packets Router filters out packets with IP options; enabled or
disabled
Administrative MTU MTU size configured on the profile
TCP MSS value Maximum segment size for TCP SYN packets traveling
through the interface
Inactivity Timer Inactivity timer setting; enabled or disabled
Route Map Name Route map applied to the IP interface subscriber; enabled
or disabled
Auto Detect Router automatically detects packets that do not match any
entries in the demultiplexer table; enabled or disabled
Auto Configure Dynamic creation of subscriber interfaces on a primary IP
interface; enabled or disabled
IGMP Enabled or disabled
static-groups Displays address of any static groups configured for IGMP
Input policy Name of input policy and whether statistics are enabled or
disabled
Output policy Name of output policy and whether statistics are enabled or
disabled
PPP Keepalive PPP keepalive period, in seconds
PPP Magic Number Enabled or disabled
PPP Magic Number Mismatch Indicates whether the router is configured
to ignore the LCP peer magic number and retain the PPP connection when
the peer has not negotiated an LCP magic number: ignore (ignore the peer
magic number mismatch and retain the PPP connection), or reject (router
terminates the PPP connection if it detects a peer magic number mismatch)
PPP Peer DNS Priority Enabled or disabled
PPP Peer WINS Priority Enabled or disabled
559
Monitoring Upper-Layer Dynamic Interfaces and Profiles