Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 126

JUNOSe 11.0.x Link Layer Configuration Guide
96
Monitoring ATM
OAM loopback frequency Frequency with which OAM loopback cells are
transmitted (when enabled), in seconds
OAM up retry count Number of consecutive successfully looped OAM cells
required to mark the VC as Up
OAM down retry count Number of consecutive unsuccessfully looped OAM
cells required to mark the VC as Down
OAM loopback retry frequency Frequency with which OAM cells are
transmitted in verification mode, in seconds
OAM CC verification Whether CC verification is enabled or disabled
OAM CC Type Whether the VC is a sink or a source, or both sink and source
end point
OAM CC Flow Type End-to-end or segment
OAM Current CC state
Ready OAM CC is not enabled
Active OAM CC cell flow is running
Activation Failed OAM CC activation failed
Wait Activate Waiting for interface to come up before the software
sends the activation request
Wait Activation Confirmation Waiting for activation confirmation from
the peer
Wait DeActivate Waiting for interface to come up before the software
sends the deactivation request
Wait DeActivation Confirmation Waiting for deactivation confirmation
from the peer
InOamF5Cells Number of F5 OAM cells received on this circuit
InOamCellDiscards Number of received OAM cells that were dropped;
dropped cells include unsupported and invalid F5 cells. The
InOamCellDiscards counter is not incremented after an OAM flush is
performed with the atm oam flush command. For more information about
the InOamCellDiscards counter, see "Rate Limiting for F5 OAM Cells" on
page 21.
InF5EndLoopCells Total number of F5 end-to-end loopback cells received
on this circuit, which is the sum of the following counts:
InF5EndLoopCommands Number of F5 end-to-end loopback commands
received
InF5EndLoopResponses Number of F5 end-to-end loopback responses
received