Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 694

JUNOSe 11.0.x Link Layer Configuration Guide
664
Monitoring Dynamic Interfaces and Profiles
host1#show vlan subinterface fastEthernet 4/6.1000053
Interface
---------------------- ------ ---- -------- -------- --------- -------
FastEthernet 4/6.1000053
Auto configure interface(s)
Detected dynamic interface
Interface types in lockout
Lockout state (seconds)
------------------------------- --- --- ------- ------- ----
IP
PPPoE
In: Bytes 1040, Packets 15
Multicast 0, Broadcast 1
Errors 0, Discards 0
Out: Bytes 984, Packets 15
Multicast 0, Broadcast 1
Errors 0, Discards 0
ARP Statistics:
In: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Out: ARP requests 0, ARP responses 0
Errors 0, Discards 0
Example 5 Displays status information for dynamic VLAN subinterfaces that
are created based on agent-circuit-identifier information
host1#show vlan subinterface
Interface
---------------------- -------- ---- -------- -------- --------- ---------
FastEthernet 4/0.1
*
FastEthernet 4/0.2
*
2 vlan subinterfaces found
* Created via agent circuit identifier
host1#show vlan subinterface agent-circuit-identifier
Interface
------------------------- -------- --------------------------
FastEthernet 4/0.1
FastEthernet 4/0.2
See show vlan subinterface.
Status MTU Svlan Id Vlan Id Ethertype
Up 1526 100 53
: IP PPPoE
: PPPoE
: none
: Min Max Current Elapsed Next
1 300 0
1 300 0
Status MTU Svlan Id Vlan Id
Up 1522 2 ----
Up 1522 2 ----
Svlan Id Agent-Circuit-Identifier
2 ----
2 0200D0CB2729E5
Type
0x9100 Dynamic
0 1
0 1
Ethertype Type
---- Dynamic
---- Dynamic