Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 526

JUNOSe 11.0.x Link Layer Configuration Guide
interface gigabitEthernet
interface tenGigabitEthernet
ip address
pppoe auto-configure
496
Configuring PPPoE Dynamic Interfaces over PPPoE Static Interfaces
Use the no version to remove IP from an interface or a subinterface. You must
issue the no version from the highest level down; you cannot remove an interface
or a subinterface if the one above it still exists.
See interface fastEthernet.
Use to select a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface.
To specify a Gigabit Ethernet interface for ERX7xx models, ERX14xx models,
and ERX310 router, use the slot/port[.subinterface ] format.
To specify a Gigabit Ethernet interface or a 10-Gigabit Ethernet interface for E120
and E320 routers, use the slot/adapter/port[.subinterface ] format.
For more information, see chapter Configuring Ethernet Interfaces in JUNOSe
Physical Layer Configuration Guide.
Examples
host1(config)#interface gigabitEthernet 1/0
host1(config)#interface gigabitEthernet 4/0/1
host1(config)#interface tenGigabitEthernet 4/0/1
Use the no version to remove IP from an interface. You must issue the no version
from the highest level down; you cannot remove an interface or subinterface if
the one above it still exists.
See interface gigabitEthernet.
See interface tenGigabitEthernet.
Use to assign an IP address and subnet mask to an interface or a subinterface.
Example
host1(config-if)#ip address 192.1.1.1 255.255.255.0
Use the no version to remove an IP address or disable IP processing.
See ip address.
Use to set up the router to dynamically create PPPoE subinterfaces on the PPPoE
major interfaces.
Example
host1(config-subif)#pppoe auto-configure
Use the no version to remove this configuration.
See pppoe auto-configure.