Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 353

For e series broadband services routers - link layer configuration
Hide thumbs Also See for JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010:
Table of Contents

Advertisement

Packets received Number of incoming packets received on this interface
Bytes received Number of incoming bytes received on this interface
Errored packets received Number of incoming errors received on this
interface
Packets sent Number of outgoing packets transmitted on this interface
Bytes sent Number of outgoing bytes transmitted on this interface
Errored packets sent Number of outgoing errors on this interface
Example
host1#show interfaces pos 8/0
Packet over SONET interface 8/0 is ifOperUp
Description: houston80 pos interface
snmp trap link-status = disabled
Encapsulation ppp
SONET path operational status: up
time since last status change: 00:20:37
SONET operational status:
time since last status change: 00:20:37
loopback not set
timing source is loop timing
framing type is SONET
Crc type checking - CRC32
Hdlc mru = 4470
Hdlc mtu = 4470
Hdlc interface speed = 155520000
Hdlc scrambling is off
5 minute input rate 24910848 bits/sec, 1023242 packets/sec
5 minute output rate 24905728 bits/sec, 1023233 packets/sec
Interface statistics
Packets received
Bytes received
Errored packets received
Packets sent
Bytes send
Errored packets sent
See show interfaces.
Chapter 9: Configuring Packet over SONET
up
1066995954
3836558195
0
1055275550
3039550548
0
Monitoring POS
323

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.0.x

Table of Contents