Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 403

Type Lockout for PPPoE Clients" on page 498 in "Configuring Dynamic
Interfaces" on page 465
Min Minimum lockout time, in seconds
Max Maximum lockout time, in seconds
Total clients in active lockouts Number of PPPoE clients currently
undergoing dynamic encapsulation type lockout
Total clients in lockout grace period Number of PPPoE clients currently
in a lockout grace period
Example 1
host1#show pppoe interface atm 1/0.1
PPPoE interface ATM 1/0.1 is operStatusUp (dynamic)
PPPoE interface ATM 1/0.1 has max sessions = 4000
PPPoE interface ATM 1/0.1 has acName of 111111111111111
PPPoE interface ATM 1/0.1 will not send ac info in PADS packet
PPPoE interface ATM 1/0.1 is in duplicate-protection
PPPoE interface ATM 1/0.1 will capture remote circuit ID
PPPoE interface ATM 1/0.1 has 1 active connections,
out of 1 configured subinterfaces
Assigned profile (any)
PPPoE Statistics
Counters:
PADI received
PADI transmitted
PADO received
PADO transmitted
PADR received
PADR transmitted
PADS received
PADS transmitted
PADT received
PADT transmitted
PADM received
PADM transmitted
PADN received
PADN transmitted
PAD packets received
PAD packets transmitted
Invalid PAD Packets:
Invalid Version
Invalid PAD Code
Invalid PAD Tags
Invalid PAD Tag length
Invalid PAD Type
Invalid PADI Session
Invalid PADR Session
Invalid PAD packet length 3
Invalid PAD packets
Total Invalid PAD packets
Insufficient Resources 0
Lockout Configuration (seconds): Min 5, Max 60
Chapter 10: Configuring Point-to-Point Protocol over Ethernet
: baseProfile
0
1
1
0
0
1
1
0
0
0
1
0
0
0
2
2
0
0
0
0
0
0
0
0
3
373
Monitoring PPPoE