Monitoring Cisco Hdlc - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

11.

Monitoring Cisco HDLC

You can monitor Cisco HDLC interfaces using the show hdlc interface command.
You can set a statistics baseline for Cisco HDLC interfaces, subinterfaces, or circuits
using the baseline hdlc interface serial command.
You can use the filtering feature of the show command to include or exclude lines
of output based on a text string you specify. For details, see show Commands in
JUNOSe System Basics Configuration Guide.
NOTE: The E120 and E320 routers output for monitor and show commands is
identical to output from other E Series routers, except that the E120 and E320 routers
output also includes information about the adapter identifier in the interface specifier
(slot/adapter/port).
baseline hdlc interface
show hdlc interface
host1:vr1(config-if)#hdlc down-when-looped
Assign an IP address to the interface.
host1:vr1(config-if)#ip address 160.1.0.1 255.255.255.0
Use to set a statistics baseline for Cisco HDLC interfaces. The router implements
the baseline by reading and storing the statistics at the time the baseline is set
and then subtracting this baseline whenever baseline-relative statistics are
retrieved.
Example
host1#baseline hdlc interface serial 2/0:1/1
There is no no version.
See baseline hdlc interface.
Use to display statistics for the specified HDLC interfaces.
You can specify the following keywords:
statistics Displays interface statistics
delta Specifies that baselined statistics are to be shown
status Displays the operational status of all configured interfaces
closed Displays interfaces with administrative status Closed
config Displays configuration information
down Displays interfaces with operational status Down
Chapter 14: Configuring Cisco HDLC
Monitoring Cisco HDLC
461