Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 556

JUNOSe 11.0.x Link Layer Configuration Guide
ipv6 mtu
ipv6 nd
ipv6 nd managed-config-flag
ipv6 nd other-config-flag
ipv6 nd prefix-advertisement
526
Configuring a Dynamic Interface from a Profile
Use the no version to disable MLD on an interface.
See ipv6 mld.
Use to set the maximum transmission unit size of IPv6 packets sent on an
interface.
Example
host1(config-profile)#ipv6 mtu 1000
Use the no version to restore the default value, 0, which means that the router
takes the value from a lower protocol layer.
See ipv6 mtu.
Use to enable the IPv6 Neighbor Discovery process on an interface.
Example
host1(config-profile)#ipv6 nd
Use the no version to disable the Neighbor Discovery process.
See ipv6 nd.
Use to set the "managed address configuration" flag in IPv6 router
advertisements.
Example
host1(config-profile)#ipv6 nd managed-config-flag
Use the no version to clear the flag from IPv6 router advertisements.
See ipv6 nd managed-config-flag.
Use to set the "other stateful configuration" flag in IPv6 router advertisements.
Example
host1(config-profile)#ipv6 nd other-config-flag
Use the no version to clear the flag from IPv6 router advertisements.
See ipv6 nd other-config-flag.