Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 681

show pppoe interface
Chapter 16: Configuring Dynamic Interfaces Using Bulk Configuration
Field descriptions
Type Interface type
Total Total number of interfaces on this column
Static Number of static interfaces on this column
Dynamic Number of dynamic interfaces on this column
Example
host#show columns
Interface columns:
------------------
Type
-------------------- ---------- ---------- ----------
Bridged Ethernet
IP over ATM
PPP
PPPoE
See show columns.
Use to display summary information about the encapsulation type lockout
parameters configured for PPPoE clients on a dynamic PPPoE subinterface
column.
The following field descriptions and example include only the portion of the
show pppoe interface command display relevant to lockout configuration for
PPPoE clients. For more information about using this command, see "show
pppoe interface" on page 371 in "Configuring Point-to-Point Protocol over
Ethernet" on page 325.
Field descriptions
Lockout Configuration (seconds) Encapsulation type lockout settings for
the PPPoE client associated with the dynamic PPPoE subinterface column
Min Minimum lockout time, in seconds
Max Maximum lockout time, in seconds
Total clients in active lockouts Number of PPPoE clients currently
undergoing dynamic encapsulation type lockout
Total clients in lockout grace period Number of PPPoE clients currently
in a lockout grace period; for more information about the lockout grace
period, see "Guidelines for Configuring Encapsulation Type Lockout" on
page 477 in "Configuring Dynamic Interfaces" on page 465.
Example
host1#show pppoe interface atm 3/0.101
. . .
Lockout Configuration (seconds): Min 5, Max 60
Total clients in active lockouts: 0
Total clients in lockout grace period: 0
Total Static Dynamic
4 2
4 2
22 12
10 5
Monitoring Dynamic Interfaces and Profiles
2
2
10
5
651