Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 194

JUNOSe 11.0.x Link Layer Configuration Guide
164
Monitoring Upper-Level Protocols over Ethernet
Duplex Mode Duplex option for this interface
Operational Duplex option currently used
Administrative Setting for duplex that you specified
Speed Line speed for this interface
Operational Current rate at which packets are processed
Administrative Setting for line speed that you specified
Debounce Debounce configuration for this interface
State is Enabled, Disabled
Interval is Number of seconds that this interface maintains a given
state before the state change is reported to the upper-layer links
Clear arp State of the removal of the ARP entries on an interface with
redundant ports
Enabled Clears ARP entries on the interface when the primary link
fails
Disabled Maintains ARP entries on the interface until the specified
timeout elapses
Link Link information for this interface
Operational Link Selected Port that the I/O module is currently using:
primary or secondary
Administrative link selected Port that the I/O module is configured to
use:
primary Only primary port is configured to operate
secondary Only redundant port is configured to operate
automatically Software controls port redundancy automatically
Link Failover Timeout
the router uses a different active link
Primary link selected x times Number of times that the I/O has used the
primary port since the module was last rebooted
Secondary link selected x times Number of times that the I/O has used the
secondary port since the module was last rebooted
Primary/Secondary link signal detected, Primary/Secondary link signal not
detected Specifies the port (primary or secondary) on which the router
detects a signal
5 minute input rate Data rates based on the traffic received in the last 5
minutes
5 minute output rate Data rates based on the traffic sent in the last 5
minutes
Time to wait for a failed link to be active before