Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 583

Example 3 Displays status information for all ATM subinterfaces in the
dormantLockout state
host1#show atm subinterface status dormantLockout
Interface ATM-Prot VCD VPI VCI
---------- -------- --- --- --- ------ ----- ---- ------------- ---------
ATM 2/0.101 RFC-1483 101
1 interface(s) found
Example 4 Displays the current state of a specific ATM subinterface
host1#show atm subinterface atm 2/0.101
Interface ATM-Prot VCD VPI VCI Type Encap MTU
----------- -------- --- --- --- ----- ----- ---- ------------ ---------
ATM 2/0.101 RFC-1483 101
Auto configure status
Auto configure interface(s)
Detected 1483 encapsulation
Detected dynamic interface
Interface types in lockout
Lockout state (seconds)
------------------------------- --- ---- ------- ------- ----
IP
BridgedEnet
PPP
PPPoE
Assigned profile (IP)
Assigned profile (BridgedEnet): beth
Assigned profile (PPP)
Assigned profile (PPPoE)
Assigned profile (any)
BridgedEnet subscriber info
Username: elaine@jpeterman.com
Password: putty
Authenticate: enabled
SNMP trap link-status: disabled
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
Example 5 Displays the current state of a specific ATM subinterface created
on the PVC with the specified VPI and VCI values
Monitoring Upper-Layer Dynamic Interfaces and Profiles
Chapter 15: Configuring Dynamic Interfaces
Circuit
Type Encap MTU Status
0 101 PVC AUTO 9180 dormantLockout Static
Circuit
0 101 PVC AUTO 9180 dormantLockout Static
: dynamic
: IP bridgedEthernet
: AUTO
: none
: IP
: Min Max Current Elapsed Next
1 30 16
900 3600 0
1 300 0
1 300 0
: ipoa
: ppptest
: pppoetest
: none assigned
:
0
1904
0
0
0
0
14
0
Interface
Type
Interface
Status Type
PPP PPPoE
7 30
0 900
0 1
0 1
553