Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 122

JUNOSe 11.0.x Link Layer Configuration Guide
show atm vc
92
Monitoring ATM
Assigned VC class
SNMP trap link-status: disabled
Advisory receive speed: 2000
InPackets:
InBytes:
OutPackets:
OutBytes:
InErrors:
OutErrors:
InPacketDiscards:
InPacketsUnknownProtocol: 0
OutDiscards:
1 interface(s) found
See show atm subinterface.
Use to display a summary of all configured ATM virtual circuits (VCs) and reserved
VC ranges.
You can specify one or more of the following keywords individually or in
combination:
vpi Displays VCs on a specific VPI
category Displays VCs that have a specific service category
status Displays VCs with a certain status
You can also specify the reserved keyword with no other keywords to display
only a summary of all reserved VC ranges on the router. This includes VPI/VCI
ranges reserved for use by dynamic ATM 1483 subinterfaces and by MPLS.
Field descriptions
Interface Interface number
VPI Virtual path identifier
VCI Virtual channel identifier
VCD Virtual circuit descriptor
Type Type of circuit: PVC
Encap Encapsulation method: AUTO, AAL5, AAL0, MUX, SNAP, ILMI,
F4-OAM
Category Service type configured on the VC: UBR, UBR-PCR, NRT-VBR,
RT-VBR, or CBR
Rx/Tx Peak Peak rate, in Kbps
Rx/Tx Avg Average rate, in Kbps
Rx/Tx Burst Maximum number of cells that can be burst at the peak cell
rate
: dsl-subscriber-class
5119
358672
5107
357510
0
0
3
0