Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 574

JUNOSe 11.0.x Link Layer Configuration Guide
1.
2.
3.
4.
5.
atm pvc
auto-configure
544
Configuring a Dynamic Interface from a Profile
Configure a physical interface.
host1(config-if)#interface atm 2/1.10
Configure a PVC by specifying the VCD, the VPI, the VCI, and the encapsulation
type.
host1(config-subif)#atm pvc 10 100 22 aal5snap
host1(config-subif)#atm pvc 10 100 22 aal5autoconfig
Apply an existing profile.
host1(config-subif)#profile ip holland
Assign subscriber identification.
host1(config-subif)#subscriber ip user ispname domain abc.com
password 3fds9jpt
Enable the dynamic encapsulation type.
host1(config-subif)#auto-configure ip
Use to configure a PVC on an ATM interface. Select one of the following
encapsulation options:
aal5autoconfig Enables the autodetection of the 1483 encapsulation
(LLC/SNAP or VC multiplexed).
aal5snap Specifies a LLC encapsulated circuit; the LLC/SNAP header
precedes the protocol datagram.
aal5mux ip Specifies a VC multiplexed circuit. This option is used for IP
only.
Example
host1(config-subif)#atm pvc 6 0 11 aal5autoconfig
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure an ATM subinterface to support a dynamic interface. Specifies
one or more types of dynamic encapsulation that the ATM 1483 subinterface
detects and accepts.
For detailed information about how to use this command, see "auto-configure"
on page 481.
Example 1 Enables autodetection for the bridged Ethernet encapsulation type
using the default lockout time range, 1–300 seconds
host1(config-subif)#auto-configure bridgedEthernet