Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 93

vbr-nrt
vbr-rt
vc-class atm
You must issue the exit command from ATM VC Class Configuration mode for
the configuration to take effect.
Example
host1(config-vc-class)#ubr 5000
host1(config-vc-class)#exit
Use the no version to restore the default service category, UBR without a PCR.
See ubr.
Use to configure the VBR-NRT service category on an ATM data PVC.
For detailed information about how to use this command, see "vbr-nrt" on
page 49.
You must issue the exit command from ATM VC Class Configuration mode for
the configuration to take effect.
Example
host1(config-vc-class)#vbr-nrt 50000 10000 150
host1(config-vc-class)#exit
Use the no version to restore the default service category, UBR without a PCR.
See vbr-nrt.
Use to configure the VBR-RT service category on an ATM data PVC.
For detailed information about how to use this command, see "vbr-rt" on page 50.
You must issue the exit command from ATM VC Class Configuration mode for
the configuration to take effect.
Example
host1(config-vc-class)#vbr-rt 200000 30000 400
host1(config-vc-class)#exit
Use the no version to restore the default service category, UBR without a PCR.
See vbr-rt.
Use to create and name a VC class for an ATM data PVC.
You must specific a VC class name of up to 32 alphanumeric characters.
The vc-class atm command accesses ATM VC Class Configuration mode, from
which you can configure a set of attributes for the PVC including the service
category, encapsulation method, F5 OAM options, and Inverse ARP.
You must issue the exit command from ATM VC Class Configuration mode for
the VC class configuration to take effect.
Chapter 1: Configuring ATM
Configuring ATM VC Classes
63