Upper-Layer Dynamic Interface Configurations - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

For e series broadband services routers - link layer configuration
Hide thumbs Also See for JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010:
Table of Contents

Advertisement

Upper-Layer Dynamic Interface Configurations

E Series routers support the following types of upper-layer dynamic interface
configurations:
E Series routers also support the following types of upper-layer dynamic interfaces
over static VLAN interfaces:
Internet Protocol version 4 (IPv4) is supported for all of these upper-layer dynamic
interface configurations.
Currently, Internet Protocol version 6 (IPv6) is supported only when PPP or MLPPP
is the layer immediately below the IPv6 layer in the interface column. Dynamic IPv6
is not supported directly over static ATM 1483, dynamic bridged Ethernet, or dynamic
VLANs. Upper-layer dynamic interface columns that support IPv6 include the
following:
Dynamic IP over static ATM 1483 (IPoA)
Dynamic IP over dynamic PPP over static ATM 1483
Dynamic IP over dynamic PPP over dynamic PPPoE over static ATM 1483
Dynamic IP over dynamic bridged Ethernet over static ATM 1483
Dynamic IP over dynamic MLPPP over static ATM 1483
Dynamic IP over dynamic MLPPP over dynamic PPPoE over static ATM 1483
Dynamic IP over dynamic PPP over dynamic PPPoE subinterface over static
PPPoE major interface (with or without VLANs)
Dynamic IP over dynamic MLPPP over dynamic PPPoE subinterface over static
PPPoE major interface (with or without VLANs)
Dynamic IP over dynamic MLPPP over dynamic PPPoE (with or without VLANs)
Dynamic Subscriber Interfaces
IP over Ethernet
IP over PPP over Ethernet
Dynamic IPv6 over dynamic PPP over static ATM 1483
Dynamic IPv6 over dynamic MLPPP over static ATM 1483
Dynamic IPv6 over dynamic PPP over dynamic PPPoE over static ATM 1483
Dynamic IPv6 over dynamic MLPPP over dynamic PPPoE over static ATM 1483
Dynamic IPv6 over dynamic PPP over dynamic PPPoE subinterface over static
PPPoE major interface (with or without VLANs)
Dynamic IPv6 over dynamic MLPPP over dynamic PPPoE subinterface over static
PPPoE major interface (with or without VLANs)
Chapter 15: Configuring Dynamic Interfaces
Overview
467

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.0.x

Table of Contents