Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 120

JUNOSe 11.0.x Link Layer Configuration Guide
90
Monitoring ATM
InBytes Number of bytes received on this interface
OutPackets Number of packets transmitted on this interface
OutBytes Number of bytes transmitted on this interface
InErrors Number of errors received on this interface
OutErrors Number of outgoing errors on this interface
InPacketDiscards Number of incoming packets discarded on this interface
InPacketsUnknownProtocol Number of incoming packets with an unknown
protocol type
OutDiscards Number of outgoing packets discarded on this interface
Example 1 Displays the current state of all ATM subinterfaces
host1#show atm subinterface
Interface ATM-Prot VCD VPI VCI Type
----------- -------- --- --- --- ----- ----- ---- -------------- ---------
ATM 2/0.101 RFC-1483 101
ATM 2/0.102 RFC-1483 102
ATM 2/0.103 RFC-1483 103
3 interface(s) found
Example 2 Displays summary information for all ATM subinterfaces shown in
Example 1
host1#show atm subinterface summary
3 subinterfaces: 1 up, 0 down,
1 dormant, 1 dormantLockout,
0 lowerLayerDown, 0 not present
Example 3 Displays status information about the current state of all ATM
subinterfaces in the dormantLockout state
host1#show atm subinterface status dormantLockout
Interface ATM-Prot VCD VPI VCI Type
----------- -------- --- --- --- ----- ----- ---- ------------- ---------
ATM 2/0.101 RFC-1483 101
1 interface(s) found
Example 4 Displays the current state of a specific ATM subinterface
host1#show atm subinterface atm 2/0.101
Interface ATM-Prot VCD VPI VCI Type
----------- -------- --- --- --- ----- ----- ---- ------------ ---------
ATM 2/0.101 RFC-1483 101
Auto configure status
Auto configure interface(s)
Detected 1483 encapsulation
Detected dynamic interface
Circuit
Encap MTU
0 101 PVC AUTO 9180 dormantLockout Static
0 102 PVC AUTO 9180 up
0 103 PVC AUTO 9180 dormant
Circuit
Encap MTU
0 101 PVC AUTO 9180 dormantLockout Static
Circuit
Encap MTU
0 101 PVC AUTO 9180 dormantLockout Static
: dynamic
: IP bridgedEthernet
: AUTO
: none
Interface
Status Type
Dynamic
Static
Interface
Status Type
Interface
Status Type
PPP PPPoE