Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 682

JUNOSe 11.0.x Link Layer Configuration Guide
show pppoe interface lockout-time
show pppoe subinterface
652
Monitoring Dynamic Interfaces and Profiles
See show pppoe interface.
Use to display detailed information about the current encapsulation type lockout
condition for each PPPoE client associated with a dynamic PPPoE subinterface
column on a static PPPoE major interface.
Field descriptions
PPPoE interface Specifier for the PPPoE interface
Lockout Configuration (seconds) Encapsulation type lockout settings for
the PPPoE client associated with the dynamic PPPoE subinterface column
Min Minimum lockout time, in seconds
Max Maximum lockout time, in seconds
Total clients in active lockouts Number of PPPoE clients currently
undergoing dynamic encapsulation type lockout
Total clients in lockout grace period Number of PPPoE clients currently
in a lockout grace period; for more information about the lockout grace
period, see "Guidelines for Configuring Encapsulation Type Lockout" on
page 477 in "Configuring Dynamic Interfaces" on page 465
Client Address Source MAC address of the PPPoE client
Current Current lockout time, in seconds; displays 0 (zero) if the PPPoE
client is not undergoing lockout
Elapsed Time elapsed into the lockout time, in seconds; displays 0 (zero)
if the PPPoE client is not undergoing lockout
Next Lockout time that the router uses for the next lockout event, in seconds
Example
host1#show pppoe interface atm 3/0.101 lockout-time
PPPoE interface ATM 3/0.101
Lockout Configuration (seconds): Min 5, Max 60
Total clients in active lockout: 0
Total clients in lockout grace period: 0
Client Address Current Elapsed Next
-------------- ------- ------- ----
0090.1a10.165e
See show pppoe interface lockout-time.
0 0 5