Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 591

PPPOE duplicate-protect Enabled or disabled
PPPoE ACNAME Access concentrator name
PPPoE URL URL sent in PADM message to PPPoE clients
PPPoE MOTM Message of the minute sent in the PADM message to PPPoE
clients
PPPoE Service-Name Table Name of the PPPoE service name table, if
configured for the specified profile
ATM1483 Auto-configure Whether autodetection of the specified
upper-interface encapsulation type (bridged Ethernet, IP, PPP, or PPPoE) is
enabled or disabled for a dynamic ATM 1483 subinterface
ATM1483 lockout (seconds) Encapsulation type lockout setting for the
specified upper-interface encapsulation type (bridged Ethernet, IP, PPP, or
PPPoE) configured on a dynamic ATM 1483 subinterface
range Minimum lockout time–maximum lockout time, in seconds
no lockout Encapsulation type lockout is disabled
ATM1483 PVC circuit type Encapsulation setting for the PVC configured
on a dynamic ATM 1483 subinterface
aal5autoconfig Enables autodetection of the 1483 encapsulation
(LLC/SNAP or VC multiplexed)
aal5mux ip VC-based multiplexed circuit for IP only
aal5snap LLC encapsulated circuit; the LLC/SNAP header precedes the
protocol datagram
ATM1483 PVC service category Service type setting for the PVC configured
on a dynamic ATM 1483 subinterface: UBR (the default), UBR PCR, NRT-VBR,
RT-VBR, or CBR
ATM1483 PVC Peak rate Peak cell rate (PCR), in Kbps, for the PVC
configured on a dynamic ATM 1483 subinterfaces
ATM1483 PVC Avg rate Average rate, in Kbps, for the PVC configured on
a dynamic ATM 1483 subinterface; also referred to as sustained cell rate
(SCR)
ATM1483 PVC Burst size Length in cells of the burst for the PVC configured
on a a dynamic ATM 1483 subinterface; also referred to as maximum burst
size (MBS)
ATM1483 Description Text description assigned to ATM 1483 subinterfaces
that are created with this profile
ATM1483 Advisory Rx Speed Configured receive speed, in Kbps, for the
dynamic ATM 1483 subinterface. The E Series LAC sends this value to the
LNS in the RX Connect-Speed AVP [38].
Monitoring Upper-Layer Dynamic Interfaces and Profiles
Chapter 15: Configuring Dynamic Interfaces
561