Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 430

JUNOSe 11.0.x Link Layer Configuration Guide
encapsulation ppp
interface atm
ip address
400
Configuring Bridged Ethernet
Use the no version, without the MAC address, to remove bridged Ethernet as
the encapsulation method on the interface.
See encapsulation bridge1483.
Use to configure PPP as the encapsulation method for an interface.
Example
host1(config-subif)#encapsulation ppp
Use the no version to remove PPP as the encapsulation method on the interface.
See encapsulation ppp.
Use to configure an ATM interface or subinterface type.
To specify an ATM interface for ERX7xx models, ERX14xx models, and ERX310
router, use the slot/port.[subinterface ] format.
slot Number of the chassis slot
port Port number on the I/O module
subinterface Number of the subinterface in the range 1–2147483647
To specify an ATM interface for E120 and E320 routers, use the
slot/adapter/port[.subinterface ] format.
slot Number of the chassis slot
adapter Identifier for the IOA within the E320 chassis, either 0 or 1, where:
0 indicates that the IOA is installed in the right IOA bay (E120 router)
or the upper IOA bay (E320 router).
1 indicates that the IOA is installed in the left IOA bay (E120 router) or
the lower IOA bay (E320 router).
port Port number on the IOA
subinterface Number of the subinterface in the range 1–2147483647
For more information, see "Creating a Basic Configuration" on page 22 in
"Configuring ATM" on page 3.
Examples
host1(config)#interface atm 9/1.1 point-to-point
host1(config)#interface atm 5/0/1.1 point-to-point
Use the no version to remove the interface or subinterface.
See interface atm.