Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 620

JUNOSe 11.0.x Link Layer Configuration Guide
atm atm1483 auto-configure
atm atm1483 description
atm atm1483 profile
590
Configuring ATM 1483 Dynamic Subinterfaces
Use to set an advisory receive speed for ATM 1483 subinterfaces that are created
with the profile that you are configuring. This setting has no effect on data
forwarding. You can use it to indicate the speed of the client interface. When
traffic is tunneled with L2TP, the advisory receive speed is sent from the LAC to
the LNS. See LAC Configuration Prerequisites for additional information about
the advisory receive speed.
The range is 0–2147483647 kbps.
Example
host1(config-profile)#atm atm1483 advisory-rx-speed 2000
Use the no version to restore the default behavior the RX speed is not sent to
the LNS.
See atm atm1483 advisory-rx-speed.
Use to specify the types of dynamic upper-interface encapsulations that are
accepted or detected by a dynamic ATM 1483 subinterface.
Include this command in the base profile for a dynamic ATM 1483 subinterface.
For the bridged Ethernet, IP, PPP, and PPPoE encapsulation types, you can
optionally specify the lockout time range for the encapsulation type. For more
information, see "Encapsulation Type Lockout" on page 475 .
Examples
host1(config-profile)#atm atm1483 auto-configure ip lockout-time 3600 7200
host1(config-profile)#atm atm1483 auto-configure pppoe
Use the no version to terminate detection of the specified encapsulation type
See atm atm1483 auto-configure.
Use to assign a text description for ATM 1483 subinterfaces that are created with
the profile that you are configuring.
The description can be up to 255 characters.
Example
host1(config-profile)#atm atm1483 description VC_atm1
Use the no version to remove the text description.
See atm atm1483 description.
Use to add a nested profile assignment to a base profile for a dynamic ATM 1483
subinterface.
A nested profile assignment references another profile that configures attributes
for a dynamic upper-interface type over the ATM 1483 subinterface.