JUNOSe 11.0.x Link Layer Configuration Guide
show frame-relay subinterface
130
Monitoring Frame Relay
Out DE pkts Number of packets transmitted with the DE bit set
Dropped packets Number of dropped packets
Example
host1#show frame-relay pvc
PVC information for frame relay NNI interface 3/2:1/1
DLCI 101 in sub-interface 3/2:1/1.1, status is active
Number of circuit status inactive transitions is 0
Time since creation 03:27:29, last status change 01:21:29
In pkts: 0
In bytes: 0
In FECN pkts: 0
In BECN pkts: 0
In DE pkts: 0
Dropped pkts: 0
DLCI 102 in sub-interface 3/2:1/1.2, status is active
Number of circuit status inactive transitions is 0
Time since creation 03:27:28, last status change 01:21:29
In pkts: 0
In bytes: 0
In FECN pkts: 0
In BECN pkts: 0
In DE pkts: 0
Dropped pkts: 0
DLCI 103 in sub-interface 3/2:1/1.3, status is active
Number of circuit status inactive transitions is 0
Time since creation 03:27:28, last status change 01:21:29
In pkts: 0
In bytes: 0
In FECN pkts: 0
In BECN pkts: 0
In DE pkts: 0
Dropped pkts: 0
See show frame-relay pvc.
Use to display the state of the Frame Relay subinterface.
The subinterface can be in one of the following states:
Up Traffic can flow on the interface
Offline Traffic cannot flow because hardware is unavailable
Down Traffic cannot flow because of a problem in the interface at the
current protocol layer
LowerLayerDown Traffic cannot flow because of a problem in an interface
at a lower protocol layer
AdministrativelyDown Traffic cannot flow because of manual administrative
intervention
Use the optional delta keyword to specify that baselined statistics are to be
shown.
Out pkts: 0
Out bytes: 0
Out FECN pkts: 0
Out BECN pkts: 0
Out DE pkts: 0
Out pkts: 0
Out bytes: 0
Out FECN pkts: 0
Out BECN pkts: 0
Out DE pkts: 0
Out pkts: 0
Out bytes: 0
Out FECN pkts: 0
Out BECN pkts: 0
Out DE pkts: 0