Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 276

JUNOSe 11.0.x Link Layer Configuration Guide
ppp peer
ppp shutdown
ppp shutdown ip
ppp shutdown ipv6
ppp shutdown mpls
ppp shutdown osi
246
Optional Configuration Tasks
Use to force a static or dynamic PPP interface into passive mode before LCP
negotiation begins, for a period of one second. This delay enables slow clients
to start up and initiate the LCP negotiation.
Example
host1(config-if)#ppp passive-mode
Use the no version to disable passive mode.
See ppp passive-mode.
Use to resolve conflicts when the router and the PPP peer have the primary and
secondary DNS and WINS name server addresses configured with different
values.
By default, the DNS and WINS addresses configured on the router take
precedence.
Use the dns keyword or the wins keyword to configure which PPP peer address
takes precedence. This command has no effect unless both routers have the
address configured and the address is in conflict. If the PPP peer has the address
and the router does not, the peer always supplies the address regardless of how
you have configured the PPP peer.
Example
host1(config-if)#ppp peer dns
Use the no version when you want the router to take precedence during setup
negotiations between the router and the peer. If the IP addresses that the peer
sends to the router differ from the ones configured on your router, the router
returns the values that you configured as the correct values to the peer.
See ppp peer.
Use to terminate a PPP session.
To administratively disable the interface, use the ppp shutdown command.
To administratively disable IPCP, use the ppp shutdown ip command.
To administratively disable IPv6CP, use the ppp shutdown ipv6 command.
To administratively disable MPLS, use the ppp shutdown mpls command.
To administratively disable OSINLCP, use the ppp shutdown osi command.