Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 92

JUNOSe 11.0.x Link Layer Configuration Guide
oam-pvc
oam retry
ubr
62
Configuring ATM VC Classes
Example 2 Opens an F5 OAM CC segment cell flow and enables CC verification
with a sink endpoint
host1(config-vc-class)#oam cc segment sink
host1(config-vc-class)#exit
Use the no version to disable F5 OAM CC verification and restore the default
setting for cell termination, end-to-end.
See oam cc.
Use to enable generation of F5 OAM loopback cells on an ATM data PVC and,
optionally, enable F5 OAM VC integrity features on the circuit.
For detailed information about how to use this command, see "oam-pvc" on
page 53.
You must issue the exit command from ATM VC Class Configuration mode for
the configuration to take effect.
Example
host1(config-vc-class)#oam-pvc manage 15
host1(config-vc-class)#exit
Use the no version to restore the default behavior, which disables F5 OAM VC
integrity on the router and restores the default value for loopback frequency,
10 seconds.
See oam-pvc.
Use to configure F5 OAM VC integrity parameters on an ATM data PVC.
For detailed information about how to use this command, see "oam retry" on
page 54.
You must issue the exit command from ATM VC Class Configuration mode for
the configuration to take effect.
Example
host1(config-vc-class)#oam retry 5 6 3
host1(config-vc-class)#exit
Use the no version to restore the default values for the up retry count
(3 successive loopback cell responses), down retry count (5 successive loopback
cell responses), and retry frequency (1 second).
See oam retry.
Use to configure the UBR service category on an ATM data PVC.
For detailed information about how to use this command, see "ubr" on page 49.