Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 57

atm atm1483 advisory-rx-speed
NOTE: If you specify an advisory receive speed greater than 4294967 kbps, the speed
is not accurately represented in the L2TP AVP, which is in bits per second (bps).
atm atm1483 mtu
atm atm1483 shutdown
Use to enable SNMP link status traps on the AAL5 layer interface.
Example
host1(config-if)#atm aal5 snmp trap link-status
Use the no version to disable the traps.
See atm aal5 snmp trap link-status.
Use to set an advisory receive speed for an ATM 1483 subinterface. This setting
has no effect on data forwarding. You can use it to indicate the speed of the
client interface. When traffic is tunneled with L2TP, the advisory receive speed
is sent from the LAC to the LNS. See LAC Configuration Prerequisites for additional
information about the advisory receive speed.
The range is 0–2147483647 kbps.
Example
host1(config-subif)#atm atm1483 advisory-rx-speed 2000
Use the no version to restore the default behavior the RX speed is not sent to
the LNS.
See atm atm1483 advisory-rx-speed.
Use to set the MTU size for an ATM 1483 subinterface.
The range is 256–9180.
Example
host1(config-subif)#atm atm1483 mtu 7800
Use the no version to restore the default size of 9180.
See atm atm1483 mtu.
Use to set an ATM 1483 subinterface administrative state to disabled.
When you set the administrative state of the ATM 1483 subinterface to disabled,
the router automatically disables all F5 OAM services configured on the associated
VC, and prevents the VC from receiving or transmitting F5 OAM cells.
Example
host1(config-subif)#atm atm1483 shutdown
Chapter 1: Configuring ATM
Setting Optional Parameters
27