Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 328

JUNOSe 11.0.x Link Layer Configuration Guide
The following command displays PPP interface (including MLPPP interface) statistics
Sample Display Without
without baselining:
Baseline
host1#show ppp interface statistics
PPP interface serial 2/0:4/1 is up
No baseline has been set
Interface statistics
PPP interface serial 2/0:5/1 is up
No baseline has been set
Interface statistics
PPP interface serial 2/1:4/1 is up
No baseline has been set
Interface statistics
PPP interface serial 2/1:5/1 is up
No baseline has been set
298
Monitoring MLPPP
Use to set a statistics baseline for PPP interfaces including MLPPP interfaces,
either individual serial (member link) interfaces or multilink (bundle) interfaces.
Use only the serial or mlppp keywords.
For serial interfaces, specify the interface location in the format
slot/port:channel/subchannel for CT3 modules.
For MLPPP interfaces, specify the interface location as the name of the MLPPP
bundle.
The router implements the baseline by reading and storing the statistics at the
time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
When baselining is requested, the time since the last baseline was set is displayed
in hours:minutes:seconds or days/hours format. If a baseline was not set, the
following message is displayed instead:
No baseline has been set
Use the optional delta keyword with MLPPP show commands to specify that
baselined statistics are to be shown.
Example
host1#baseline ppp interface serial 2/0:1/1
There is no no version.
See baseline ppp interface.
packets
octets
errors
discards
packets
octets
errors
discards
packets
octets
errors
discards
in out
0 0
572 684
0 0
0 0
in out
0 0
572 684
0 0
0 0
in out
0 0
572 684
0 0
0 0