Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 421

5.
NOTE: You can also assign an IP template to the interface or create an unnumbered
interface instead of assigning an IP address. For details, see chapter Configuring IP
in JUNOSe IP, IPv6, and IGP Configuration Guide.
6.
atm pvc
NOTE: Do not set both the VPI and VCI values to zero.
Assign an IP address and subnet mask to the PVC.
host1(config-subif)#ip address 192.168.10.20 255.255.255.0
(Optional) Use the appropriate show commands to verify your configuration.
host1#show atm interface 0/1
host1#show atm vc 0/1 10
host1#show atm subinterface 0/1.20
For more information about using these commands, see "Monitoring ATM" on
page 69 in "Configuring ATM" on page 3.
Use to configure a PVC on an ATM interface.
The following fields are mandatory:
vcd Unique number that identifies a virtual circuit in the range
1–2147483647. The VCD value has no relationship to the VPI and VCI values
and has meaning only to the E Series router.
vpi 8-bit field in the ATM cell header. The VPI value is unique on a single
link, not throughout the ATM network, because it has meaning only to the
E Series router. The VPI value must match the value on the ATM switch.
vci 16-bit field in the ATM cell header. The VCI value is unique on a single
link, not throughout the ATM network, because it has meaning only to the
router. You cannot set both the VPI and VCI to 0.
encapsulation type:
aal5snap Specifies a logical link control (LLC) encapsulated circuit. An
LLC/Subnetwork Access Protocol (LLC/SNAP) header precedes the
protocol datagram.
aal5muxip Specifies a multiplexed circuit used for IP only.
Example
host1(config-if)#atm pvc 10 22 100 aal5snap
Use the no version to remove the specified PVC.
See atm pvc.
Chapter 11: Configuring Bridged IP
Configuring Bridged IP
391