Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 429

8.
atm pvc
encapsulation bridge1483
Configure PPP encapsulation over the PPPoE subinterface, and the IP interface
over the PPP interface.
host1(config-subif)#encapsulation ppp
host1(config-subif)#ip address 160.1.1.1 255.255.255.0
Use to configure a PVC on an ATM interface. Specify one of the following
encapsulation types:
aal5snap Specifies a logical link control (LLC) encapsulated circuit;
LLC/Subnetwork Access Protocol (LLC/SNAP) header precedes the protocol
datagram.
aal5mux ip Specifies a VC multiplexed circuit. This option is used for IP
only.
Example
host1(config-subif)#atm pvc 1 0 32 aal5snap 0 0 0
Use the no version to remove the specified PVC.
See atm pvc.
Use to configure bridged Ethernet as the encapsulation method on an interface,
and to optionally assign the MAC address to the interface.
Use the mac-address keyword to configure a specific MAC address for the
interface. Otherwise, the system MAC address is used. The same MAC address
can be used on multiple interfaces.
If the MAC address is configured, you must use the same MAC address whenever
you reenter the encapsulation bridge1483 command for the interface.
The MAC address can be configured only when the interface is created. To change
a MAC address, you must remove the interface and create it again.
Example
host1(config-subif)#encapsulation bridge1483 mac-address 0090.1a01.1234
Chapter 12: Configuring Bridged Ethernet
Configuring Bridged Ethernet
399