Figure 12: Example Of Ip, Mpls, And Pppoe Stacking Configuration - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual
For e series broadband services routers - link layer configuration
Hide thumbs
Also See for JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010:
- Configuration manual (788 pages)
Table of Contents
Advertisement
JUNOSe 11.0.x Link Layer Configuration Guide
3.
4.
5.
6.
7.
8.
Figure 12 on page 158 illustrates this configuration.
Figure 12: Example of IP, MPLS, and PPPoE Stacking Configuration Procedure
mpls
158
Configuring IP, MPLS, and PPPoE over Ethernet
host1(config-if)#ip address 192.5.127.8 255.255.255.0
Create an MPLS interface.
host1(config-if)#mpls
Create a PPPoE interface by specifying PPPoE as the encapsulation method on
the interface.
host1(config-if)#pppoe
Create a PPPoE subinterface.
host1(config-if)#pppoe subinterface fastEthernet 4/1.1
Specify PPP as the encapsulation method on the interface.
host1(config-if)#encapsulation ppp
Assign an IP address and mask.
host1(config-if)#ip address 192.6.129.5 255.255.255.0
(Optional) Configure additional PPPoE subinterfaces by completing Steps 5
through 7 using unique numbering.
Advertisement
Table of Contents
Troubleshooting
