Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 131

show atm vp
Example 1
host1#show atm vc-class
premium-subscriber-class
dsl-subscriber-class
found 2 VC class entrie(s) in the system
Example 2
host1#show atm vc-class premium-subscriber-class
Encapsulation Type
Service Category
Peak Cell Rate
OAM VC Integrity
OAM VC Integrity loop-back timer
OAM alarm down count
Example 3
host1#show atm vc-class premium-subscriber-class include-defaults
Encapsulation Type
Service Category
Peak Cell Rate
OAM VC Integrity
OAM VC Integrity loop-back timer
OAM VC Integrity Up Retry Count
OAM VC Integrity Down Retry Count
OAM VC Integrity Retry Frequency
OAM alarm down count
OAM alarm clear time out
OAM continuity check
Inverse ARP
See show atm vc-class.
Use to display detailed statistics for a specific ATM VP configured on the router.
Field descriptions
ServiceCategory Service type on the VP tunnel, if configured: UBR, UBR-PCR,
VBR-NRT, VBR-RT, or CBR
Peak Cell Rate Peak cell rate in kilobits per second, if a VP tunnel is
configured
Maximum VCI per VPI Maximum number of virtual circuits on each virtual
path
Current VCs Number of VCs currently configured on the router
InPackets Number of packets received
InBytes Number of bytes received
InCells Number of ATM cells received
Chapter 1: Configuring ATM
:AUTO
:CBR
:200 kbps
:enabled
:60 seconds
:5
:AUTO
:CBR
:200 kbps
:enabled
:60 seconds
:3
:5
:1
:5
:3 seconds
:disabled
:disabled
Monitoring ATM
101