Table 18: Pppoe Service Name Table With Entries - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual
For e series broadband services routers - link layer configuration
Hide thumbs
Also See for JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010:
- Configuration manual (788 pages)
Table of Contents
Advertisement
2.
Table 18: PPPoE Service Name Table with Entries
3.
4.
5.
pppoe-service-name-table
(Optional) From PPPoE Service Name Table Configuration mode, create entries
to populate the PPPoE service name table.
You can configure up to 16 specific service name entries per table, in addition
to the empty and unknown service name tags.
host1(config-pppoe-service-name-table)#service myISPService action drop
host1(config-pppoe-service-name-table)#service myQOSClass1 action terminate
host1(config-pppoe-service-name-table)#service myQOSClass2 action drop
host1(config-pppoe-service-name-table)#service myQOSClass3
host1(config-pppoe-service-name-table)#service empty-service-name action drop
host1(config-pppoe-service-name-table)#service unknown-service-name action
terminate
These commands build the PPPoE service name table shown in Table 18 on
page 355. This table directs the router to send a PADO packet in response to all
PADI requests containing the myQOSClass1, myQOSClass3, empty service name
tags, and unknown service name tag. The router is directed to drop all PADI
requests containing the myISPService or myQOSClass2 or the empty service
name tags.
Service Name
Action
myISPService
Drop
myQOSClass1
Terminate
myQOSClass2
Drop
myQOSClass3
Terminate
" "
Drop
unknown-service-name
Terminate
Exit PPPoE Service Name Table Configuration mode.
host1(config-pppoe-service-name-table)#exit
(Optional) Use the appropriate show command to verify the creation of the
PPPoE service name table and entries.
host1(config)#show pppoe-service-name-table name myServiceTable1
(Optional) Repeat Steps 1 through 4 to configure additional PPPoE service name
tables on the router.
Use from Global Configuration mode to create a PPPoE service name table.
You can create a maximum of 16 PPPoE service name tables per E Series router.
Chapter 10: Configuring Point-to-Point Protocol over Ethernet
Configuring PPPoE Service Name Tables
355
Advertisement
Table of Contents
Troubleshooting
