Platform Considerations; Module Requirements - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide
After you configure the bridged Ethernet interface, you configure the VLANs, S-VLANs,
and the supported higher-level protocols in the same way that you configure them
over Ethernet interfaces.
For more information, see:

Platform Considerations

You can configure bridged Ethernet on the following E Series Broadband Services
Routers:

Module Requirements

For information about the modules that support bridged Ethernet on ERX14xx models,
ERX7xx models, and the ERX310 router:
For information about the modules that support bridged Ethernet on the E120 and
E320 routers:
396
Platform Considerations
S-VLAN oversubscription is not supported on bridged Ethernet interfaces.
"Configuring VLAN and S-VLAN Subinterfaces" on page 169 for introductory
information about VLANs and S-VLANs.
"Configuring VLANs over Bridged Ethernet" on page 403 and "Configuring S-VLANs
over Bridged Ethernet" on page 408 for examples that illustrate VLAN and S-VLAN
configurations over bridged Ethernet.
E120 router
E320 router
ERX1440 router
ERX1410 router
ERX710 router
ERX705 router
ERX310 router
See ERX Module Guide, Table 1, Module Combinations for detailed module
specifications.
See ERX Module Guide, Appendix A, Module Protocol Support for information about
the modules that support bridged Ethernet.
See E120 and E320 Module Guide, Table 1, Modules and IOAs for detailed module
specifications.
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support bridged Ethernet.