Configuring Vlan Dynamic Subinterfaces - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide
interface atm
mpls-relay

Configuring VLAN Dynamic Subinterfaces

E Series routers support configuration of dynamic VLAN subinterfaces over static
VLAN major interfaces over Ethernet.
608
Configuring VLAN Dynamic Subinterfaces
Use to configure a PVC on an ATM interface.
Specify the VCD, the VPI, the VCI, and the encapsulation type. For more
information about these parameters, see "Creating a Basic Configuration" on
page 22 in "Configuring ATM" on page 3.
You can create a PVC within an existing bulk-configured VC subrange, or a
bulk-configured VC subrange that includes the VPI and VCI values of an existing
PVC.
Use the aal0 encapsulation keyword to cause the router to receive raw ATM cells
on this circuit and to forward the cells without performing AAL5 packet
reassembly.
Example
host1(config-subif)#atm pvc 10 100 22 aal0
Use the no version to remove the specified PVC.
See atm pvc.
Use to select an ATM interface or ATM 1483 subinterface.
For information about specifying the ATM interface or subinterface, see "interface
atm" on page 595.
Examples
host1(config)#interface atm 5/0.1
host1(config)#interface atm 4/0/2
Use the no version to remove the interface or subinterface.
See interface atm.
Use to route layer 2 traffic to the specified router.
For detailed information about using the mpls-relay command, see chapter
Configuring Layer 2 Services over MPLS in JUNOSe BGP and MPLS Configuration
Guide.
Example
host1(config-if)#mpls-relay 10.10.100.2 45
Use the no version to negate this command.
See mpls-relay.