Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 108

JUNOSe 11.0.x Link Layer Configuration Guide
78
Monitoring ATM
OutCells Number of cells transmitted on this interface
InErrors Number of incoming errors received on this interface
OutErrors Number of outgoing errors on this interface
InPacketDiscards Number of incoming packets discarded on this interface
InByteDiscards Number of incoming bytes discarded on this interface
InCellErrors Increments when a T3 or an E3 ATM interface receives cells
for a VPI or VCI that is not configured on that interface
Field descriptions specific to the applicable physical interface. In Example 1, the
output contains the following physical interface fields:
SONET path operational status State of the SONET path interface: up, down,
lowerLayerDown
time since last status change Time since last reported change to the SONET
path operational status
SONET operational status State of SONET interface: up, down,
lowerLayerDown
time since last status change Time since last reported change to the SONET
operational status
PHY Type Physical port type on which this interface is running
Framing Framing type of the physical interface
TX clocking Clocking type for the physical interface
Loopback Loopback status for the physical interface: enabled, disabled
Receive FIFO Overruns Number of times received FIFO was overrun
qos-mode-port Status of SAR backpressure: enabled, disabled
queue Hardware packet queue associated with the specified traffic class
and interface
Forwarded packets, Bytes Number of packets and bytes forwarded on this
queue
Dropped committed packets, Bytes Number of committed packets and
bytes that were dropped
Dropped conformed packets 0, Bytes 0 Number of conformed packets and
bytes that were dropped
Dropped exceeded packets 0, Bytes 0 Number of exceeded packets and
bytes that were dropped
Interface ATM interface identifier