References; Before You Configure Pppoe; Configuring Pppoe Over Atm - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide

References

For more information about PPPoE, consult the following resources:
NOTE: IETF drafts are valid for only 6 months from the date of issuance. They must
be considered as works in progress. Please refer to the IETF Web site at
http://www.ietf.org for the latest drafts.

Before You Configure PPPoE

Before you attempt to configure a PPPoE interface, configure the physical interface
over which PPPoE traffic will flow. The procedures described in this chapter assume
that a physical interface has been configured.

Configuring PPPoE over ATM

This section provides an example of a common PPPoE over ATM configuration.
See the following resources for additional information:
To configure PPPoE over ATM:
1.
2.
336
References
DSL Forum Technical Report (TR)-101 Migration to Ethernet-Based DSL
Aggregation (April 2006)
Extensions to a Method for Transmitting PPP over Ethernet
(PPPoE) draft-carrel-info-pppoe-ext-00.txt (November 2000 expiration)
IEEE 802.1q (Virtual LANs)
RFC 2516 Method for Transmitting PPP over Ethernet (PPPoE) (February 1998)
"Configuring ATM" on page 3 Provides detailed information about ATM
technology and line interface module capabilities.
"Configuring Bridged Ethernet" on page 393 Provides configuration information
about Bridged Ethernet, which allows multiple upper-layer interface types (IP
and PPPoE) to be simultaneously multiplexed over the same interface.
"Configuring Dynamic Interfaces" on page 465 Provides detailed information
about configuring ATM to support dynamic interfaces.
Configuring Upper-Layer Protocols over Static Ethernet Interfaces on page 153
Configure a physical interface.
host1(config)#interface atm 0/1
Configure the ATM 1483 subinterface.
host1(config-if)#interface atm 0/1.20