Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 177

show frame-relay map
Number of interface down transitions is 0
Time since last status change 00:05:39
Example 2
host1#show frame-relay lmi interface mlframe-relay TEST
LMI information for frame relay DTE interface mlframe-relayTEST
DTE parameter N391 is 6, N392 is 3, N393 is 4, T391 is 10
Configured LMI type is ANSI, status is up
Number of interface down transitions is 0
Time since last status change 00:06:20
Enquiries sent: 39
Full enquiries sent: 7
Enquiry responses received: 39
Full enquiry responses received: 7
Async updates received: 0
Unknown messages received: 0
Loss of sequencing detected: 0
No response timeouts: 0
Last sequence number sent: 39
Last sequence number received: 39
See show frame-relay lmi.
Use to display the current Frame Relay and MLFR map entries.
Field descriptions
subinterface Name and subinterface number of the MLFR bundle in the
format bundle-name.subinterface-number
State of the subinterface One of the following states:
Up—Traffic can flow on the interface
Offline—Traffic cannot flow because hardware is unavailable
Down—Traffic cannot flow because of a problem in the interface at the
current protocol layer
LowerLayerDown—Traffic cannot flow because of a problem in an
interface at a lower protocol layer
AdministrativelyDown—Traffic cannot flow because of manual
administrative intervention
DLCI number Decimal value, hexadecimal value, and value as it appears
on the wire of the DLCI
Example
host1#show frame-relay map
Frame relay sub-interface mlframe-relayTEST.1 (up): DLCI 16(0x10,0x4)
Frame relay sub-interface mlframe-relayTEST.2 (up): DLCI 17(0x11,0x14)
See show frame-relay map
Chapter 3: Configuring Multilink Frame Relay
Monitoring MLFR
147