Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual page 553

ip policy
ip redirects
ip route-cache flow sampled
ip route-map ip-subscriber
ip sa-validate
Use to assign a policy list to the ingress or egress of an interface to which the
profile is attached.
Example
host1(config-profile)#ip policy secondary-input my-policy
Use the no version to remove the association between a policy list and a profile.
See ip policy.
Use to enable the sending of redirect messages if the software is forced to resend
a packet through the same interface on which it was received.
Example
host1(config-profile)#ip redirects
Use the no version to remove the assignment from the profile.
See ip redirects.
Use to enable J-Flow statistics on the interface.
Example
host1(config-profile)#ip route-cache flow sampled
Use the no version to delete J-Flow statistics from the profile.
See ip route-cache flow sampled.
Use to configure an interface for route-map processing and specify the route
map that is applied to the IP interface subscriber.
Example
host1(config-profile)#ip route-map ip-subscriber chicagoRouteMap
Use the no version to delete the route map.
See ip route-map ip-subscriber.
Use to enable source address validation on an IP interface.
Source address validation verifies that a packet has been sent from a valid source
address.
Example
Chapter 15: Configuring Dynamic Interfaces
Configuring a Dynamic Interface from a Profile
523