Figure 36: Example Of Pppoe Stacking - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide
3.
4.
5.
6.
7.
8.
Figure 36 on page 348 illustrates the interface stack for this configuration.

Figure 36: Example of PPPoE Stacking

encapsulation ppp
348
Configuring PPPoE for Ethernet Modules
host1(config-if)#pppoe
Create a PPPoE subinterface.
host1(config-if)#pppoe subinterface fastEthernet 4/1.1
Specify PPP as the encapsulation method on the interface.
host1(config-subif)#encapsulation ppp
(Optional) Configure an access concentrator (AC) name on the PPPoE interface.
host1(config-subif)#pppoe acname CYM9876
(Optional) Set up the router to prevent a client from establishing more than one
session using the same MAC address.
host1(config-subif)#pppoe duplicate-protection
Assign an IP address and mask.
host1(config-if)#ip address 192.6.129.5 255.255.255.0
(Optional) Configure additional PPPoE subinterfaces by completing Steps 3
through 7 using unique numbering.
Use to specify PPP as the encapsulation method for the interface.
Example
host1(config-if)#encapsulation ppp
Use the no version to disable PPP on an interface.
See encapsulation ppp.