Configuring Static Vlan Subinterfaces Within Vlan Subranges; Creating Static Vlan Subinterfaces Within Vlan Subranges - Juniper JUNOSE SOFTWARE 11.0.X - LINK LAYER CONFIGURATION GUIDE 4-1-2010 Configuration Manual

JUNOSe 11.0.x Link Layer Configuration Guide
vlan bulk-config shutdown

Configuring Static VLAN Subinterfaces Within VLAN Subranges

You can do either of the following on an E Series router:
The following sections describe how to perform these tasks.
The example procedures in this section show how to configure static VLAN
subinterfaces within VLAN subranges by using the same loopback interface referenced
by multiple unnumbered IP interfaces. Instead of assigning a different IP address to
each physical interface, the first example assigns an IP address to a loopback interface
(loopback 0). Each physical interface is then configured as an unnumbered IP
interface, referencing the same loopback interface.

Creating Static VLAN Subinterfaces Within VLAN Subranges

You can configure a static VLAN subinterface with a VLAN whose VLAN ID falls within
an existing bulk-configured VLAN subrange.
636
Configuring VLAN Dynamic Subinterfaces
Example
host1(config-if)#vlan bulk-config test modify svlan-range 200 250 1 3
There is no no version.
See vlan bulk-config modify.
Use to administratively disable (shut down) a specified VLAN subrange or all
subranges in a VLAN range. The administrative state of a VLAN subrange is
enabled by default.
Disabling the VLAN subrange deletes all dynamic VLAN subinterfaces on the
affected subranges. You can use the show vlan subinterface command to
monitor the progress of the removal of all dynamic VLAN subinterfaces for the
specified subrange.
No dynamic VLAN subinterfaces can subsequently be created for the subrange
until you restore the administrative state to enabled by using the no vlan
bulk-config shutdown command.
Example
host1(config-if)#vlan bulk-config test shutdown svlan-range 200 250 1 3
Use the no version to enable the specified VLAN subrange or all subranges in a
VLAN range.
See vlan bulk-config shutdown.
Create a static VLAN subinterface within an existing bulk-configured VLAN
subrange
Create a bulk-configured VLAN subrange that includes an existing static VLAN
subinterface