Ip Bgp Policy Route-Map Community - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip bgp policy route-map community

Configures the action to be taken on the community attribute when a match is found.
ip bgp policy route-map name sequence_number community [none | no-export | no-advertise |
no-export-subconfed | num:num]
Syntax Definitions
name
sequence_number
none
no-export
no-advertise
no-export-subconfed
num:num
Defaults
parameter
string
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
By default, no action is taken on a community attribute when a match on a route is found.
•
The default behavior can be reset by setting the value to "none".
•
The ip bgp policy community-list
create and set permit/deny actions for a community path list. This command is used in conjunction with
ip bgp policy route-map
Examples
-> ip bgp policy route-map routemap1 1 community 400:1 500:1
-> ip bgp policy route-map routemap1 1 community 400:1 500:1 community-mode replace
Release History
Release 6.1; command was introduced.
page 25-126
The route map name.
The route map sequence number. The valid range is 1–255.
Removes the community restrictions on the community section of the
route map.
Routes in this community are advertised within the AS but not beyond
the local AS.
Routes in this community are not advertised to any peer.
Routes in this community are not advertised to any external BGP peer.
The community number, given in the form of the AS number and the
community number, separated by a colon, as defined in RFC 1997.
default
none
and ip bgp policy community-list action
community-mode.
commands are used to
OmniSwitch CLI Reference Guide
BGP Commands
June 2012