BGP Commands
show ip bgp neighbors policy
Displays the incoming and outgoing prefix6 list policy identifiers configured for the specified BGP IPv4
peer.
show ip bgp neighbors policy ipv4_address
Syntax Definitions
ipv4_address
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
This command displays all of the configured policies for the router, or the polices configured for a specific
BGP IPv4 peer.
Examples
-> show ip bgp neighbors policy
Neighbor address
Neighbor autonomous system
Neighbor output policy map name
Neighbor input policy map name
Neighbor output aspath-list name
Neighbor input aspath-list name
Neighbor output prefix-list name
Neighbor input prefix-list name
Neighbor output community-list name = <none>,
Neighbor input community-list name
Neighbor soft reconfiguration
Neighbor output prefix6-list name
Neighbor input prefix6-list name
Neighbor address
Neighbor autonomous system
Neighbor output policy map name
Neighbor input policy map name
Neighbor output aspath-list name
Neighbor input aspath-list name
Neighbor output prefix-list name
Neighbor input prefix-list name
Neighbor output community-list name = <none>,
Neighbor input community-list name
Neighbor soft reconfiguration
Neighbor output prefix6-list name
Neighbor input prefix6-list name
OmniSwitch CLI Reference Guide
A 32-bit IP address.
=
0.0.0.0,
= enabled
=
0.0.0.1,
June 2012
= 1,
= <none>,
= <none>,
= <none>,
= <none>,
= <none>,
= <none>,
= <none>,
= uniqeLocal
= uniqeLocal
= 1,
= <none>,
= <none>,
= <none>,
= <none>,
= <none>,
= <none>,
= <none>,
= enabled
= UniqueLocal
= UniqueLocal
page 25-173