BGP Commands
ip bgp policy prefix-list ge
Configures the lower limit on the length of the prefix to be matched.
ip bgp policy prefix-list name ip_address ip_mask ge value
Syntax Definitions
name
ip_address
ip_mask
value
Defaults
parameter
value
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
The default value of zero indicates there is no lower limit on the length of the prefix to be matched.
•
This command is used in conjunction with the
matching range. The two commands can be combined, as show in the Example section below.
•
The ge (lower limit) value must be greater than or equal to the prefix length (8 in the example below)
and less than or equal to the le (upper limit) value.
Examples
-> ip bgp policy prefix-list prefixListA 14.0.0.0 255.0.0.0 ge 8 le 16
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Prefix list name.
IP address of the prefix list.
Mask of the prefix list.
The lower limit value in the range 0 to 32.
default
0
ip bgp policy prefix-list le
June 2012
command to set the prefix
page 25-115