Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1662

output definitions (continued)
Autonomous system Number
BGP Router Id
Confederation Id
IGP Synchronization Status
Minimum AS origin interval
Default Local Preference
Route Reflection
Cluster Id
Missing MED Status
Aspath Comparison
Always Compare MED
Fast External Fail Over
Log Neighbor Changes
Multi path
Graceful Restart
page 25-150
The AS assigned to the local BGP speaker through the
ip bgp autonomous-system
The IP address for the local BGP speaker.
Shows the confederation number assigned to the local BGP speaker. If
the BGP speaker does not belong to a confederation, then this value
will be zero (0). Confederation numbers are assigned through the
bgp confederation identifier
Indicates whether BGP is synchronizing its routing tables with those
on non-BGP routers handling IGP traffic (such as a RIP or OSPF
router). This value is configured through the
command.
The frequency, in seconds, at which routes local to the autonomous
system are advertised. This value is configured through the
origin-interval command.
The local preference that will be assigned to routes that do not already
contain a local preference value. This default value is configured
through the ip bgp default local-preference
Indicates whether the local BGP speaker is acting as a route reflector
for its AS. This value is configured through the
reflection command.
The IP address for cluster in route reflector configurations using multi-
ple, redundant route reflectors. A value of 0.0.0.0 indicates that a clus-
ter is not set up. This value is configured through the
command.
Indicates the MED value that will be assigned to paths that do not con-
tain MED values. Missing MED values will either be assigned to the
32
worst possible value
(2 -1)
set using the ip bgp bestpath med missing-as-worst
default, missing MED values are treated as best.
Indicates whether the AS path will be in used in determining the best
route. This value is configured through the
ignore command.
Indicates whether multi-exit discriminator (MED) values are being
compared only for internal peers or also for external peers. This value
is configured through the
Indicates whether Fast External Failover has been enabled or disabled.
When enabled a BGP sessions will be reset immediately after a con-
nection to a directly connected external peer goes down. This value is
configured through the ip bgp fast-external-failover
Indicates whether logging of peer state changes is enabled or disabled.
This value is configured through the
command.
Indicates whether support for multiple equal cost paths is enabled or
disabled. This value is configured through the
paths command.
Indicates whether graceful restart is enabled or disabled.
command.
command.
ip bgp synchronization
command.
ip bgp client-to-client
or the best possible value (0). This value is
ip bgp bestpath as-path
ip bgp always-compare-med
ip bgp log-neighbor-changes
ip bgp maximum-
OmniSwitch CLI Reference Guide
BGP Commands
ip
ip bgp as-
ip bgp cluster-id
command. By
command.
command.
June 2012