Ip Bgp Log-Neighbor-Changes - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

BGP Commands

ip bgp log-neighbor-changes

Enables or disables the logging of peer state changes. If enabled, this logging tracks changes in the state of
BGP peers from ESTABLISHED to IDLE and from IDLE to ESTABLISHED. Viewing peer state logging
requires that certain debug parameters be set.
ip bgp log-neighbor-changes
no ip bgp log-neighbor-changes
Syntax Definitions
N/A
Defaults
This command is disabled by default.
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
The BGP protocol must be disabled (using the ip bgp status command) before using this command.
Examples
-> ip bgp log-neighbor-changes
-> no ip bgp log-neighbor-changes
Release History
Release 6.1; command was introduced.
Related Commands
ip bgp status Disables BGP within the router.
MIB Objects
alaBgpGlobal
alaBgpPeerChanges
page 25-26 OmniSwitch CLI Reference Guide June 2012