Pm Motor Setup In Vvc - Danfoss iC2 Application Manual

Application Guide | iC2-Micro Frequency Converters
Parameter index
4.2.2.1
4.2.2.2
4.2.2.4
4.2.2.3
4.2.2.5
2.
Set following parameters for optimum performance in VVC+ mode, extra motor data is required to set up the following
parameters.
Parameter index
4.2.3.1
4.2.3.2
4.2.3.4
4.2.3.6
VVC+ is the most robust control mode. In most situations, it provides optimum performance without further adjustments.
Run a complete AMA for best performance. See

PM Motor Setup in VVC+

5.4.3
Prerequisites
1.
Set P 4.2.1.1 Motor Type to the following options to activate PM motor operation:
[1] PM, Non-salient SPM or [3] PM, Salient IPM.
¢
2.
Select [0] Speed Open Loop in P 5.4.2 Operation Mode.
Procedure
1.
Set the following parameters using the motor name plate and motor datasheet.
Parameter index
4.2.2.3
4.2.3.7
4.2.2.5
4.2.1.2
Danfoss A/S © 2024.03
Parameter name
Nominal Power
Nominal Voltage
Nominal Frequency
Nominal Current
Nominal Speed
Parameter name
Stator Resistance (Rs)
Rotor Resistance (Rr)
Stator Leakage Reactance
X1
Main Reactance Xh
5.4.5 Automatic Motor Adaptation
Parameter name
Nominal Current
Motor Cont. Rated Torque
Nominal Speed
Number of Poles
Recommended setting
As shown on nameplate.
As shown on nameplate.
As shown on nameplate.
As shown on nameplate.
As shown on nameplate.
Recommended setting
As shown on motor
datasheet.
As shown on motor
datasheet.
As shown on motor
datasheet.
As shown on motor
datasheet.
(AMA).
Recommended setting
As shown on motor datasheet.
As shown on motor datasheet.
As shown on motor datasheet.
As shown on motor datasheet.
AB413939445838en-000301 / 130R1254 |
Parameter number
120
122
123
124
125
Parameter number
130
131
133
135
Parameter number
124
126
125
139
51