Danfoss iC2 Application Manual page 147

Application Guide | iC2-Micro Frequency Converters
Parameter
2262
number:
Data type:
uint16
P 5.2.16 Watchdog Response
Use this parameter to select the timeout function. The timeout function activates when the control word fails to be updated within the
time period specified in P 5.2.17 Watchdog Delay.
Default value:
0 [Off]
Parameter
804
number:
Data type:
enum
The following are the selections for the parameter.
Selection number
0
1
2
3
4
5
6
7
8
26
P 5.2.17 Watchdog Delay
Use this parameter to enter the maximum time expected to pass between the reception of 2 consecutive telegrams. If this time is
exceeded, it indicates that the serial communication has stopped, and the function selected in P 5.2.16 Watchdog Response is then
carried out.
Default value:
1.0
Parameter
803
number:
Data type:
uint16
Danfoss A/S © 2024.03
Unit:
Access type:
Parameter type:
Unit:
Access type:
Selection name
Off
Freeze Output
Stop
Jogging
Max. Speed
Stop and Trip
Qstop and Trip
Select Setup 1
Select Setup 2
Trip
Parameter type:
Unit:
Access type:
AB413939445838en-000301 / 130R1254 |
s
Read/Write
Selection
–
Read/Write
Range (0.5–6000.0)
s
Read/Write
147