Danfoss iC2 Application Manual page 156

Application Guide | iC2-Micro Frequency Converters
Selection number Selection name
2 Logic AND
3 Logic OR
Reference (Menu Index 5.5.3)
7.6.4.3
P 5.5.3.1 Reference Range
Use this parameter to select the range of the reference signal and the feedback signal.
Default value:
0 [Min–Max]
Parameter
300
number:
Data type:
enum
The following are the selections for the parameter.
Selection number Selection name
0 Min–Max
1 -Max–Max
P 5.5.3.2 Reference/Feedback Unit
Use this parameter to select the unit to be used in Process PID Control references and feedback.
Default value:
3 [Hz]
Parameter
301
number:
Data type:
enum
The following are the selections for the parameter.
Selection number
0
1
2
3
4
5
156
| Danfoss A/S © 2024.03
Selection description
The fieldbus/serial communication port and a digital input
trigger the preset reference selection.
The fieldbus/serial communication port or a digital input triggers
the preset reference selection.
Parameter type:
Unit:
Access type:
Selection description
Select the range of the reference signal and the feedback signal.
Signal values can be positive only, or positive and negative.
For both positive and negative values (both directions), relative
to P 5.8.1 Rotation Direction.
Parameter type:
Unit:
Access type:
Selection name
None
%
RPM
Hz
Nm
PPM
Selection
–
Read/Write
Selection
–
Read/Write
AB413939445838en-000301 / 130R1254