Danfoss iC2 Application Manual page 193

Application Guide | iC2-Micro Frequency Converters
P 6.6.3 Link Setups
Use this parameter to link or unlink setups. The link ensures synchronizing of the parameters that cannot be changed while the motor is
running. When setups are linked, it is possible to shift from 1 setup to another during operation. When selecting linked, the parameter
values of Edit Set-up are overwritten with the values of the other setup.
Default value:
20
Parameter
12
number:
Data type:
enum
The following are the selections for the parameter.
Selection number
0
20
P 6.6.4 Set-up Copy
Use this parameter to copy parameters between set-ups.
Default value:
0
Parameter
51
number:
Data type:
enum
The following are the selections for the parameter.
Selection number
0
1
2
9
P 6.6.6 Reset Mode
Use this parameter to define whether the frequency converter waits for a manual reset, or resets itself automatically after tripping. In
manual reset mode, press the Stop/Reset button or use digital inputs to reset the frequency converter.
Default value:
0
Parameter
1420
number:
Data type:
enum
Danfoss A/S © 2024.03
Parameter type:
Unit:
Access type:
Selection name
Not linked
Linked
Parameter type:
Unit:
Access type:
Selection name
No copy
Copy from Set-up 1
Copy from Set-up 2
Copy from Factory Set-up
Parameter type:
Unit:
Access type:
AB413939445838en-000301 / 130R1254 |
Selection
–
Read/Write
Selection
–
Read/Write
Selection
–
Read/Write
193