Danfoss iC2 Application Manual page 133

Micro frequency converters
Table of Contents

Advertisement

Application Guide | iC2-Micro Frequency Converters
P 4.4.4.4 Low Speed Load Comp.
Enter the % value to compensate voltage in relation to load when the motor is running at high speed and obtain the optimum U/f
characteristic. The motor size determines the frequency range within which this parameter is active.
Default value:
100
Parameter
160
number:
Data type:
int16
P 4.4.4.5 Res. Damp Gain
Enter the resonance damping value. Use the parameter and P 4.4.4.6 Res. Damp High Pass Time Constant to help eliminate high
frequency resonance problems. To reduce resonance oscillation, increase the value of P 4.4.4.5 Res. Damp Gain.
Default value:
Size Related
Parameter
164
number:
Data type:
uint16
P 4.4.4.6 Res. Damp High Pass Time Constant
Set the parameter and P 4.4.4.5 Res. Damp Gain to help eliminate high frequency resonance problems. Enter the time constant that
provides the best dampening.
Default value:
Size Related
Parameter
165
number:
Data type:
uint16
P 4.4.4.7 Damping Gain
The damping gain stabilizes the PM machine to run the PM machine smooth and stable. The value of Damping gain controls the
dynamic performance of the PM machine. High damping gain gives low dynamic performance and low damping gain give high dynamic
performance. The dynamic performance is related to the machine data and load type. When the damping gain is too high or low the
control becomes unstable.
Default value:
120
Parameter
114
number:
Data type:
int16
P 4.4.4.8 High Speed Filter Time Const.
This time constant is used above 10% rated speed. Obtain quick control through a short damping time constant. However, if this value is
too short, the control gets unstable.
Default value:
Size Related
Danfoss A/S © 2024.03
Parameter type:
Unit:
Access type:
Parameter type:
Unit:
Access type:
Parameter type:
Unit:
Access type:
Parameter type:
Unit:
Access type:
Parameter type:
AB413939445838en-000301 / 130R1254 |
Range (0–300)
%
Read/Write
Range (0–500)
%
Read/Write
Range (Size Related)
s
Read/Write
Range (Size Related)
%
Read/Write
Range (Size Related)
133

Advertisement

Table of Contents
loading

Table of Contents