Danfoss iC2 Application Manual page 192

Application Guide | iC2-Micro Frequency Converters
The following are the selections for the parameter:
Selection number
5
6
7
Parameter Handling (Menu Index 6.6)
7.7.4
P 6.6.1 Active Set-up
Use this parameter to select the setup to control the drive functions. Use Multi setup for remote selection.
Default value:
1
Parameter
10
number:
Data type:
enum
The following are the selections for the parameter.
Selection number
1
2
9
P 6.6.2 Programming Set-up
Use this parameter to select the setup to be edited. The setup is configured by control panel when it is accessed by control panel, and by
RS485 when accessed by RS485.
Default value:
9
Parameter
11
number:
Data type:
enum
The following are the selections for the parameter.
Selection number
1
2
9
192
| Danfoss A/S © 2024.03
Selection name
Constant-on Mode
Constant-off Mode
On-when-inverter-is-on-else-off Mode
Parameter type:
Unit:
Access type:
Selection name
Set-up 1
Set-up 2
Multi Set-up
Parameter type:
Unit:
Access type:
Selection name
Set-up 1
Set-up 2
Active Set-up
Selection
–
Read/Write
Selection
–
Read/Write
AB413939445838en-000301 / 130R1254